Voltage Multiplier and Divider Card
Model D11005-000

• 115 VAC 50/60 Hz, internally fused at 0.3 AMPS

ISOLATION VOLTAGE

• 2400V peak at 1 second or 1500 VRMS

LINEARITY

• ±0.5% of 10 VDC span

SIGNAL INPUTS

• Potentiometer Input (Input A & B) +15 VDC available to source a 2K to 10K Ohm potentiometer.
  The 10 VDC input range should be selected for this type of input.
• Voltage Input (Input A & B)
  7 selectable ranges with 100K to Ohm input impedance.

Note: Negative input voltages cannot be used at Input A when the D11005-000 is used in the Divide Mode of Operation. input types

• Auxiliary Input A
  This allows a fixed or variable signal (-10 VDC to +10 VDC) to be summed directly with the scaled input signal at Input A. Isolation is maintained from the Auxiliary Input A to Input B signals and the Output.
• Auxiliary Input B
  This allows a fixed or variable signal (-10 VDC to +10 VDC) to be summed directly with the scaled input signal at Input B. Isolation is maintained from the Auxiliary Input B to Input A signals and the Output.
• Summing Input
  This input allows a fixed or variable signal (-10 VDC to +10 VDC) to be summed directly with the output. Isolation is not maintained between the summing input and the output.

OUTPUT TYPES

• Voltage Output
  This circuit allows the output to source a voltage level into a minimum resistance of 500 OHMS. (Lower load resistance may affect output linearity.)
• Current Output
  This circuit allows the output to source a regulated current of up to 20mA into a maximum resistance of 500 OHMS. Using the BIAS Potentiometer, the output can source a 4-20mA signal.
• Meter Output
  This output can be used to source a voltage level to a meter with a minimum 2K internal resistance. Its range can be set by the METER RANGE Potentiometer.